1:10 Dragster Turbo 4370KV, brushless set

The 1:10 Dragster Turbo 4370KV brushless set brings a matched sensorless drive package to RC car builds that call for sharp acceleration and high top-end speed. The combination of an 8T brushless motor and a waterproof electronic speed controller is designed for 1:10 applications, with the motor rated at 4370KV and up to 488W for fast-revving on-road setups and hard-charging off-road runs on suitable battery combinations. The controller is specified for 60A continuous current and 360A peak current, with 0.0007 Ohm resistance, 2A/5V BEC output, dimensions of 51 x 36 x 36 mm and a weight of 80 g. Programming is possible via Program-Card 500906303. The motor uses a 4-pole layout, supports up to 12V, draws up to 66A with a minimum current of 3.2A, and measures 35.8 x 50 mm at 148 g. A 3.175 mm motor shaft with 15 mm shaft length and 4 mm gold connectors completes the hardware package for clean installation in compatible chassis. For running setups, 2S LiPo and 6-cell NiMH are specified for on-road and off-road use, while 3S LiPo and 9-cell NiMH are specified for on-road use only. Wet and damp conditions such as rain and puddles are supported, but the vehicle and components must not be submerged under water. The set includes the brushless motor, brushless controller and instructions.